LabSat 3 Firmware
Version: 01.09b1099
Upgrade Instructions
NOTE: Only LabSat 3 customers with unit serial numbers 033353 or above can use firmware version 01.05b1033 and higher to enable CAN arbitration.
LabSat 3 customers with unit serial numbers lower than 033353 that have not been upgraded (purchased before the end of March 2014) will need to send the unit in for an upgrade.
For more information on the remote control function please contact your distributor or write to labsat@racelogic co.uk.
SatGen v3 Software
Version: 3.13.1
PC requirements
This is a full version of SatGen which runs with the dongle (?) you receive when purchasing the software. Without the dongle the software is restricted to run for only 120 seconds when creating GPS only scenarios.
If you are currently using the SatGen API, please contact requesting an updated API version compatible with this software (3.13.1).
LabSat 3 PC Comms Driver
Version: 6.8.8.0
LabSat 3 Communication Drivers are required to connect a Windows PC to the LabSat for NMEA data via the A to B USB cable.