久久综合伊人77777

  • <table id="5tnp0"><option id="5tnp0"></option></table>
  • <table id="5tnp0"><strike id="5tnp0"></strike></table>
      <acronym id="5tnp0"><label id="5tnp0"></label></acronym>

    1. <pre id="5tnp0"><ruby id="5tnp0"></ruby></pre>
        Last updated: 12/2018

        LabSat 3 Firmware

        Version: 01.09b1099
        Upgrade Instructions

        NOTE: Only LabSat 3 customers with unit serial numbers 033353 or above can use firmware version 01.05b1033 and higher to enable CAN arbitration.

        LabSat 3 customers with unit serial numbers lower than 033353 that have not been upgraded (purchased before the end of March 2014) will need to send the unit in for an upgrade.

        For more information on the remote control function please contact your distributor or write to labsat@racelogic co.uk.

        Last updated: 10/2020

        SatGen v3 Software

        Version: 3.13.1
        PC requirements

        This is a full version of SatGen which runs with the dongle (?) you receive when purchasing the software. Without the dongle the software is restricted to run for only 120 seconds when creating GPS only scenarios.

        If you are currently using the SatGen API, please contact requesting an updated API version compatible with this software (3.13.1).

        Last updated: 06/2015

        LabSat 2 / LabSat Software

        Version: 2.8.0
        Installation for Windows

        Last updated: 12/2014

        RACELOGIC Upgrader

        Version: 1.2b78
        Required to upgrade LabSat 2

        Last updated: 02/2014

        LabSat 3 PC Comms Driver

        Version: 6.8.8.0

        LabSat 3 Communication Drivers are required to connect a Windows PC to the LabSat for NMEA data via the A to B USB cable.

        久久综合伊人77777
      1. <table id="5tnp0"><option id="5tnp0"></option></table>
      2. <table id="5tnp0"><strike id="5tnp0"></strike></table>
          <acronym id="5tnp0"><label id="5tnp0"></label></acronym>

        1. <pre id="5tnp0"><ruby id="5tnp0"></ruby></pre>